
2357011431, 235-70-11431 Spacer Komatsu
Description
The Komatsu 2357011431 spacer is a machined ring or block that sets a fixed distance between two components on a shaft or a bolted joint. It is also written 235-70-11431. Where it sits Our catalog work places this spacer in the circle drawbar, circle drive related parts group. It sits in the fasteners and hardware range, and we weighed it in-house at 3.92 kg. Brand Komatsu Part type Spacer Weight 3.92 kg What a spacer does It holds bearings, gears and other parts at the right distance along the axis, and it carries clamp load through the stack. Its faces must stay parallel and its length must stay within tolerance, or the clearances the design relies on are lost. How it wears and when to replace it Fretting or wear on the faces shortens the stack. Over-torque can deform it. Corrosion can bond it to the shaft or bore. A spacer of the wrong length disturbs bearing preload. Replace a spacer whose faces are fretted, worn or deformed. Keep each spacer in its original position when you take the stack apart, and do not swap one in by eye. A length error shows up later as bearing or gear failure. Measure the length of your old spacer and compare it with this one before you order.
Frequently Asked Questions
How long does delivery take and does it cost anything?
Shipping is free and every order ships with tracking. Orders are prepared in 1–2 days and in transit 4–5 days, typically 5–7 days door-to-door.
What should I send to check this spacer against my old one?
Send the number on your old spacer, its measured length and the machine's serial number. The length matters most, because a spacer that is off in length disturbs bearing preload.