
144-60-15450 BUSHING
Description
The Komatsu 144-60-15450 bushing is a plain-bearing bushing used in the inner parts of a dozer blade lift cylinder. A bushing is a replaceable low-friction wear surface that takes the wear itself, so the more expensive parts around it do not. Where it sits Our catalogue places this number in the blade lift cylinder assemblies, under the inner parts of both the left-hand and the right-hand cylinder. The same number is used on both sides. Keep the removed piece so the two can be compared. How this kind of bushing wears The bore ovalises and the joint develops slop and misalignment. Scoring or seizure sets in when lubrication runs short or dirt gets in. Edge loading and fatigue show up when the pin is misaligned or the bushing was pressed in out of round. Fretting and corrosion attack the press-fit surface. When to replace Check the joint at scheduled service for measurable clearance and scoring, and keep the grease path clear and the seals intact. Replace the bushing together with its pin once clearance goes past the equipment maker's wear limit, not on its own. A new bushing on a worn pin wears out quickly.
Frequently Asked Questions
What should I send to confirm the fit before ordering?
Send the machine's serial number and the number on the old bushing. Our team will check them against the catalogue.
How long does shipping take, and does it cost anything?
Shipping is free and every order ships with tracking. Orders are prepared in 1–2 days and in transit 4–5 days, typically 5–7 days door-to-door.