
17A5041190, 17A-50-41190 SPACER KOMATSU
Description
The Komatsu 17A5041190 spacer is a machined ring or block that sets a fixed distance between two components on a shaft. It is also written 17A-50-41190. It sits in the pivot shaft section of the suspension, and it weighs 0.22 kg. What it does on the shaft The spacer positions the parts next to it along the shaft and carries clamp load across the stack. The stack only works if the spacer faces stay parallel and its length stays in tolerance. Signs it needs replacing Worn or fretted faces, which shorten the stack Deformation from over-torque Corrosion that has bonded the spacer to the shaft or bore When you take the shaft apart, keep each spacer in its original position and check the faces for fretting. Do not swap a spacer for one of a different length by eye. Stack length errors show up later as bearing or gear failures. To confirm you are ordering the right spacer, send us the number on your old part and the machine serial number.
Frequently Asked Questions
How long does shipping take and does it cost anything?
Shipping is free on every order, to every destination. Orders are prepared in 1–2 days and in transit 4–5 days, typically 5–7 days door-to-door, and every order ships with tracking.
Can I use a spacer of a similar length instead?
No. A wrong-length spacer disturbs the stack and the bearing preload, and the failure shows up later in the bearings or gears. Match the spacer to the number on your old part.