
23B-27-11800 BUSHING
Description
The Komatsu 23B-27-11800 bushing is a cylindrical sleeve that lines a bore and takes the wear between a pin and its housing, so the housing does not. It is also written 23B2711800. Where it sits The parts catalogue places this bushing in the front axle group. It appears under axle support, rod, tie bar, tie rod and related parts, including the layout without a steering cylinder guard. How this kind of part wears A bushing is built to wear, so the bore slowly opens up. Watch for these signs: Slop or play in the joint, caused by the bore going oval Scoring or seizure, usually from poor lubrication or dirt getting in Edge loading and fatigue where the pin is misaligned or the bushing was pressed in out of round Fretting and corrosion at the press-fit surface Replacing it Check the joint for clearance and scoring at each service, keep the grease path open and keep the seals intact. When clearance goes past the equipment maker's wear limit, replace the bushing together with its pin as a matched set. A new bushing on a worn pin loses its fit quickly.
Frequently Asked Questions
How long does shipping take and does it cost anything?
Shipping is free and every order ships with tracking. Orders are prepared in 1–2 days and in transit 4–5 days, typically 5–7 days door-to-door.
What should I send to check this bushing before I order?
Send the machine's serial number and say which front axle position the bushing sits in: axle support, rod, tie bar or tie rod. A photo of the old bushing next to its pin also helps.