
14Y5011421, 14Y-50-11421 Bushing Komatsu D65EX-15
Description
The Komatsu 14Y5011421 bushing is a cylindrical plain bearing that lines a bore and gives a pin and its housing a low-friction, replaceable wear surface. It is also written 14Y-50-11421. It weighs 0.22 kg. What it does in the joint The bushing carries the radial load while the pin turns inside it, and it sets the running clearance of the joint. It is built to wear so that the pin and the housing do not. Signs it needs replacing Joint slop or misalignment as the bore wears oval and the clearance grows Scoring or seizure, usually from poor lubrication or dirt getting into the joint Edge loading and fatigue where the mating pin is misaligned or the bushing was pressed in out of round Fretting and corrosion at the press-fit seat Fitting notes Inspect the joint at scheduled service for measurable clearance and scoring. Keep the grease path clear and the seals that hold the lubricant in intact. Replace the bushing together with its pin once clearance goes past the equipment maker's wear limit, because a new bushing on a worn pin wears out fast.
Frequently Asked Questions
How long does shipping take and does it cost anything?
Shipping is free and every order ships with tracking. Orders are prepared in 1–2 days and are in transit 4–5 days, typically 5–7 days door-to-door.
What should I send you to check this bushing against my machine?
Send the machine's serial number and the number stamped on the old bushing or its pin. If you can, add the measured bore and outside diameter of the worn part.